I think I have to change the settings in NVRAM to enable the confiugration of the Smart Array, yet all my tries faild. Yes, this can be done using the HP Array Configuration Utility. I want to know if it is possible to use the array configuration utility without losing data The controller is Smart Array P410i 512Mb. This server is brand new never used before -was stored on the client office- and I check and found that this model of servers comes with non battery Smart Array controller. I have two HP disks in RAID 1 (300 Gb), And hope to have 2 extra disks in RAID 10, with a total of 600 Gb on C. Press F8 to open the ROM Array Configuration menu. Press Ctrl+S to open the Intel Boot Agent Setup Menu. At boot time, press F8 to enter the Integrated Lights-Out 2 setup. I return back to the 146 GB SAS drives and the message just keeps appearing again. These features are dependent on the Smart Array Controller model, firmware and number of hard drives installed.
When using Rescan System, this error message appears:ģ47 The cache for Smart Array P410i Embedded Slot is not configured" "The operation has failed with an unknown error, please restart the application and attempt the operation again"
Now, we replace the drives and begin the configuration with the hp DVD and begin when we reach the point that we want to save the configurations, an error message appears:
Configuration details To configure HP Smart Array controllers, use the HP Array Configuration Utility (either hpacuxe(8) or hpacucli(8)) or the Offline ROM-based Configuration Utility.
I have got a brand new hp ProLiant D元80 G6 server with embedded smart array P410i controller, I got 146 GB SAS drives and wanted to change them with 300 GB SAS drives before installation. Smart Array P700M Smart Array P212 Smart Array P410 Smart Array P410i Smart Array P411 Smart Array P812 Smart Array P712m Smart Array P711m StorageWorks P1210m. HPE Blog, Austria, Germany & Switzerland.